2013-05-04 by seoer3
Pneumatic grinder also known as pneumatic grinder, its basic components by the body group, transmission group, Accessories Group is composed of three parts. By high-pressure gas (Air tools general working environment requirements of the gas pressure in 0.63MP) drive motor, sent by air motor eccentric device, the pneumatic grinding disk to maintain planetary motion, usually with pneumatic grinder grinding disc 2-inch grinding plate 3 inch grinding plate 6-inch 5-inch grinding plate grinding disc specifications. Uses and applications of pneumatic grinding machine (pneumatic grinder) Industry: The processing of wood furniture, machinery and equipment processing industry rust lighting, high-intensity grinding wheel industry jobs, automotive sheet metal, putty grinding abrasive manufacture. Impact of bad questions pneumatic grinding machine (pneumatic grinder): Blade wear in pneumatic tools, bearing damage, damage to the Woodruff key, disc bearing damage Pneumatic grinder Maintenance note: 1) before and after each time you use a tool by the tool air inlet filling 3 to 4 drops of dedicated air and maintenance of oil and idling for 2-3 seconds in order to reduce wear and extend tool life. 2) ensure that the gas source supply tools dry and free of impurities, the gas pressure is normal. 3) regular cleaning, refueling and maintenance, the timely replacement of worn-out parts abrasive belt.
keywords:grinding disc
2013-07-12 by seoer3

As a rule, the original surface flatness better jobs, uniform grinding technology, uniform grinding capacity, the processing will continue well after the surface flatness. But for the original workpiece surface flatness is poor, uniform grinding machine technology can make the flatness of the rear surface of the workpiece is also very good, it's hard to believe. Suppose that a ring-shaped workpiece before machining, flatness is poor, the outside of high low high inside the workpiece, the grinding, the workpiece is only one convex portion in contact with the abrasive and grinding away participate. Thus, in the actual grinding process, the contact between the workpiece and the abrasive is a constant diameter, increasing the outer diameter of the ring, this ring until it reaches the workpiece outer diameter, the nominal contact between the workpiece and the abrasive area not in the continuing increases. The uneven surface of the workpiece, which in the processing, is the same height as the projections on the workpiece and the abrasive surface contact points, forming a contact surface, if we can ensure that the abrasive abrasive grinding it in contact with the workpiece is formed on the surface of track density distribution, for the milling machining, the contact surface of the workpiece material are continuously uniform abrasive grinding wheelcutting off, the height of the projections are gradually decreased, so that the entire machining surface of the workpiece has a high flatness, which the principle is to grind the workpiece evenly.

keywords:grinding disc
Total 25 Items 13 pages/Current is Page11     First | Last | Previous | Next